C4 Fabrication 2010-Current 4Runner Overland Series Half Swing Rear Bumper
Take your 4Runner to the next level with the C4 Overland Series Half Swing Rear Bumper.
- License plate mount kit with light.
- Bolt-on receiver hitch that maintains factory tow capacity. (hitch not officially rated)
- Camp table included on every swing out.
- Holes for CB antenna mounts included at the top corner of each swing out.
- Zip tie tabs and relief cuts included on all swing outs in key areas to allow for easy routing of wiring.
**Please Note: This item will ship to a freight location near you or a specified business location.
-License plate mount kit with light.
-Bolt-on receiver hitch that maintains factory tow capacity. (hitch not DOT weight rated)
-Camp table included on every swing out.
-Holes for CB antenna mounts included at the top corner of each swing out.
-Zip tie tabs and relief cuts included on all swing outs in key areas to allow for easy routing of wiring.
-Full replacement, no cut design.
-When bolt on hitch is removed this is the highest clearance available of any rear bumper for 5th gen 4runner.
-Multiple mounting hole patterns on swing outs allow for various accessory mounting configurations.
-Swing out latching systems are easy to use, heavy duty and greatly minimize swing arm shake compared to other brands on the market.
-Main bumper structure designed with extra bracing inside to greatly reduce bumper twist and sag when swing out’s are open.
-Swing out’s fit up to 35″ tire.
-Bumper mounting system allows bumper to adjust in every direction so the perfect fit and finish can be achieved.
-Light weight steel filler piece attaches to the body of the vehicle below the tail light. This piece allows for a tight fit around the tail light and an even reveal along the bumper lines to prevent unsightly gaps.
-Compatible with C4 Summit hatch ladder.
-Compatible with GOBI ladder.
-Retains backup camera functionality.
-All mounting brackets and hardware included for install.
-Base bumper with no swing out’s weighs 200lbs
-Made from various thicknesses of steel to reduce weight as much as possible while maintaining a very strong bumper.
-Not available in aluminum.
-Ships bare steel, no powder coating options available.
-Tire mount must be removed to bolt on other accessories.
-Single (2 Gallon Rotopax) can be mounted flat on the swing arm without use of our mount.
-Maxtrax brand mounting pins recommended / RotoPax brand mount not included &; required to use with our mount.
-Our Rotopax/Maxtrax Combo Mount is ideal for stacking up to 2 4 Gallon Rotopax and 4 Maxtrax stacked while maintaining space for our vertical Hi-Lift Mount.
-All of our mounts can be adjusted vertically on our swing arms according to preference.
Please allow 8 to 12 weeks production time